Maul Tech ATV - MACHINE SHOP

 

Machining Operations Performed at Maul Tech ATV

We have the right machine for the most any job!  You've invested in us and we've put the money right back  into our business to make a one stop shop for you.   

 

Here are some pictures of actual machines at Maul Tech ATV.

 

Bridgeport Milling Machine

13 x 40 Engine Lathe Miller AC Tig Welder 50 Ton Press Arbor Press

 

 

   
Shock Dyno Spring Tester Tire Machine    

 

Here are some pictures of actual jobs we've done at the shop


Carburetor and Throttle body boring (we can do straight or taper boring)

Carburetor Boring Prices

Straight Boring $205
Taper Boring $255
Bell Adapter for CRF FCR Carb $80
43.5mm Venturi (must use for over 41.75mm) $65
Butterfly for Throttle Body $70


Cam Degreeing and we always have to make adapters for each new bike that we do.  Here's an example of what has to be done.

7


We now have special fixtures that put your crankshaft 100% in tru.  It holds the webs from being thrown out of phase when pressing the halves together.

New connecting rod service is $140 not including the new rod.


We can indicate and flycut most any cylinder or cylinder head.  You can see why this Yamaha Rhino 700 was using antifreeze!

   


We have the knowledge to cut most any wire harness into a race harness.  You can keep what accessories you like too.  This just shows how much can be cut off a TRX450R.


Custom Steering Stabilizer Seals. The stock ones wouldn't hold up so we made these.


Brake drums on the Foreman ATV's are usually rusted like this so we make them work like new again.


We carry most Timeserts for Japanese models.  If you strip your threads out we can install one of these.


We have done some other custom jobs on the side when time allows such as this in floor radiant heaters with on demand hot water heaters.


After our motorhome sprung a leak in it's Hydrohot and the company wanted $8000 for a repair we decided to fix it ourself.  $150 in parts later it's as good as new.